17/10/2023 18:49:24
Panel - Aero Shield - Rear (Remove and Replace)
Correction code 1203020012 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Bolts (x11) that attach the rear aero shield panel to the vehicle |
|
|
Reuse |
Remove
- Raise and support the vehicle. See GUID-0ECF2493-88F6-48E9-ADBB-9AE1D52E217C.html.
- Remove the push clips (x2) located at the LH and RH of the wheel house liner.
-
Remove the bolts (x11) that
attach the rear aero shield panel to the vehicle, and then remove the panel
from the vehicle.
Tip: Use of the following tool(s) is recommended:
- Cordless Ratchet/Impact Driver
- 10 mm deep socket
- Ratchet/torque wrench
- 4 in extension
Install
- Apply a thin bead of Loctite 222 to the threads of the bolts (x11) that attach the rear aero shield panel to the vehicle.
-
Install the rear aero shield
panel to the underside of the vehicle, and then install the bolts (x11) that
attach the panel to the vehicle.Tip: Use of the following tool(s) is recommended:
- Cordless Ratchet/Impact Driver
- 10 mm deep socket
- Ratchet/torque wrench
- 4 in extension
- Install the push clips (x2) located at the LH and RH of the wheel house liner.
- Remove the vehicle from the lift. See GUID-0ECF2493-88F6-48E9-ADBB-9AE1D52E217C.html.