2025-06-11

Wiper Arm - Driver Side (Remove and Replace)

Correction code 1750010012 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 1058696-00-A Wiper Arm Removal Tool
Informational PurposesAn informational icon, calling your attention
Note
This procedure is applicable to both the Driver Side and Passenger Side wiper arms, on LHD and RHD vehicles.

Torque Specifications

Table 1. Torque Specifications: Wiper Arm - Driver Side (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Nut that attaches the LH wiper arm to the wiper motor assembly
25 Nm (18.4 lbs-ft)
  • 15 mm socket
 Reuse

Remove

  1. Open the LH front door and lower the LH front window.
  2. Open the hood.
  3. Remove the LH wiper arm nut cover.
  4. Release the LH wiper arm hose nozzle.
  5. Remove the nut that attaches the LH wiper arm to the wiper module.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 15 mm socket
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  6. Use the wiper arm removal tool to remove the LH wiper arm and the blade from the vehicle.
  7. Release the tab that attaches the LH wiper blade to the LH wiper arm, and then remove the LH wiper blade from the vehicle.

Install

  1. Install the LH wiper blade to the LH wiper arm.
  2. Position the LH wiper arm and the blade onto the vehicle.
  3. Tighten the nut that attaches the LH wiper arm to the wiper module.
    25 Nm (18.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 15 mm socket
  4. Align the tip of the LH wiper blade between the two arrows on the windshield.
    Informational PurposesAn informational icon, calling your attention
    Note
    The LH wiper blade should be approximately 5 - 10mm from, and parallel to, the front edge of the windshield.
  5. Install the LH wiper arm hose nozzle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure to route the hose below the LH wiper arm.
  6. Install the LH wiper arm nut cover.
  7. Close the hood.
  8. Raise the LH front window and close the LH front door.