17/10/2023 18:56:29
Isolator - Motor Mount - Front - RH (Remove and Replace)
Correction code
3901010112
FRT
2.64
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| Bolts that attach the LH and the RH motor mount isolators to the body |
 62 Nm (45.7 lbs-ft) |
|
Replace |
Remove
- Remove the front subframe assembly. See Subframe Assembly -Front (Remove and Replace).
-
Remove and discard the bolts (x6) that attach the LH and the RH motor mount
isolators to the body, and then remove the isolators from the vehicle.
Tip: Use of the following tool(s) is recommended:
- External Torx 3/8 in E14 Socket
- 3 in extension
- Flex head ratchet/flex head torque wrench
Install
- Install an O-ring to the end of each new bolt which is used to attach the LH and the RH motor mount isolators to the body.
- Hand-tighten the new bolts that attach the motor mount isolators to the body.
-
Tighten the new bolts (x6) that attach the motor mount isolator to the
body.62 Nm (45.7 lbs-ft)Tip: Use of the following tool(s) is recommended:
- External Torx 3/8 in E14 Socket
- 3 in extension
- Flex head ratchet/flex head torque wrench
- Install the front subframe assembly. See Subframe Assembly -Front (Remove and Replace).
- Check the vehicle wheel alignment, and adjust if necessary. See Four Wheel Alignment Check (No Adjustment Needed).