06/12/2024 03:39:33

Steering Wheel (Remove and Replace)

Correction code 3205010062 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-12-06: Rearranged install steps.
  • 2024-11-06: Added step to perform Steering Wheel Post Replacement Procedure.

Torque Specifications

Table 1. Torque Specifications: Steering Wheel (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the steering wheel to the steering column
80 Nm (59.0 lbs-ft)
  • Cordless Ratchet/Impact Driver
  • 3 in extension
  • 10 mm hex socket
  • Flex head ratchet/flex head torque wrench (for installation only)
 Replace The bolt is patched

Remove

  1. Set the vehicle's front wheels straight and the steering wheel centered.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Disconnect the LV power. See LV Battery - Li-lon (Disconnect and Connect).
  4. Remove the driver airbag. See Airbag - Driver (Remove and Replace).
  5. Disconnect the steering wheel electrical wiring harness connector.
  6. Remove and discard the bolt that attaches the steering wheel to the steering column.
    Tip: Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 3 in extension
    • 10 mm hex socket
    • Flex head ratchet/flex head torque wrench (for installation only)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  7. Remove the steering wheel from the steering column.

Install

  1. Position the steering wheel onto the steering column.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  2. Install the bolt that attaches the steering wheel to the steering column.
    80 Nm (59.0 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 3 in extension
    • 10 mm hex socket
    • Flex head ratchet/flex head torque wrench (for installation only)
  3. Connect the steering wheel electrical wiring harness connector.
  4. Install the driver airbag. See Airbag - Driver (Remove and Replace).
  5. Connect the LV power. See LV Battery - Li-lon (Disconnect and Connect).
  6. Perform the Steering Wheel Post Replacement Procedure: PROC_VCLEFT_X_STEERING-WHEEL-POST-REPLACEMENT-PROCEDUREvia Toolbox: (link)via Service Mode: Chassis ➜ SCCM ➜ Steering Wheel Post Replacement Procedure
  7. Reinstall the firmware. See Software Reinstall - Touchscreen.
  8. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).