17/10/2023 18:51:43

Panel - Rear Side - Center Console - LH (Remove and Replace)

Correction code 1519010112 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the rear end panel. See Panel - Rear End - Center Console (Remove and Replace).
  2. Move the driver seat all the way backward, then move the seat back all the way down.
  3. Release the clips (x10) and tabs (x2) that attach the rear side panel to the center console.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use a trim tool and start from the rear edge of the LH side panel to release the rearmost clips.
  4. Remove the rear side panel.

Install

  1. Align the tabs (x2) in the front and rear of the LH side panel.
  2. Install the clips (x10) that attach the rear side panel to the center console.
  3. Return the driver seat to its original position.
  4. Install the rear end panel. See Panel - Rear End - Center Console (Remove and Replace).