Bracket - License Plate - Rear (China) (Remove and Replace)
Correction code
12070101002
FRT
0.06
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy
working practices.
Remove
-
Remove the screws that
attach the rear license plate bracket to the vehicle, and then remove the
bracket from the vehicle.
TIpUse of the following tool(s) is recommended:
- Torx T20 socket
- 2 in extension
- Cordless Ratchet/Impact Driver
Install
- Verify the thread inserts were not damaged during removal, and clean the surface area with IPA wipes.
-
Position the rear license
plate bracket onto the vehicle, and then install the screws that attach the
bracket to the vehicle.1.2 Nm (.9 lbs-ft)TIpUse of the following tool(s) is recommended:
- Torx T20 socket
- Wiha TorqueVario-S 0.8 Nm - 2.0 Nm screwdriver (installation only)
- Wiha torque setter