Front License Plate Bracket (NA) (Remove and Replace)
Correction code
1207010011
1207010012
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
-
Remove front license plate from license plate bracket
Note4x screws, PH2, 3 Nm
- Apply masking tape around front license plate bracket
- Remove front license plate bracket
-
Clean surface area of front license plate bracket on front fascia
NoteAllow one minute dry time
- Remove backing from horizontal double-sided tape and top portion of vertical double-sided tapes, bending it outboard of the bracket
-
Install front license plate bracket onto fascia
NotePosition front license plate bracket onto fascia, Remove remaining backing from double-sided tape
- Press license plate bracket onto fascia to wet-out double-sided tape
- Remove masking tape from front fascia
-
Install license plate onto license plate bracket
Note4x screws, PH2, 3 Nm