17/10/2023 18:54:11

Thermistor Evaporator - HVAC (Remove and Replace)

Correction code 1810010082 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the LH center console front side panel carpet. See Carpet - Side - Center Console - LH (Remove and Replace).
  2. Disconnect the evaporator thermistor electrical connector.
  3. Release the clips that attach the evaporator thermistor to the HVAC assembly, and then pull the evaporator thermistor straight out from the HVAC assembly.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.

Install

  1. Push the evaporator thermistor into the HVAC assembly until the retaining clips are fully secure.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  2. Connect the evaporator thermistor electrical connector.
  3. Install the LH center console front side panel carpet. See Carpet - Side - Center Console - LH (Remove and Replace).