17/10/2023 18:55:41

Link - Stabilizer Bar - Rear - LH (Remove and Replace)

Correction code 3103020012 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Link - Stabilizer Bar - Rear - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Nut that attaches the LH rear drop link to the LH rear stabilizer bar
55 Nm (40.6 lbs-ft)
  • 5 mm hex
  • 15 mm combination flex head wrench
  • 15 mm socket
  • Flex head ratchet/flex head torque wrench
Replace
Nut that attaches the LH rear drop link to the LH rear knuckle
55 Nm (40.6 lbs-ft)
  • 5 mm hex
  • 15 mm combination flex head wrench
  • 15 mm socket
  • Flex head ratchet/flex head torque wrench
Replace

Remove

  1. Remove the rear aero shield panel. See Panel - Aero Shield - Rear (Remove and Replace).
  2. Remove and discard the nut that attaches the LH rear drop link to the LH rear stabilizer bar.
    Tip: Use of the following tool(s) is recommended:
    • 5 mm hex
    • 15 mm combination flex head wrench
    • 15 mm socket
    • Flex head ratchet/flex head torque wrench
  3. Remove and discard the nut that attaches the LH stabilizer bar drop link to the LH rear suspension knuckle.
    Tip: Use of the following tool(s) is recommended:
    • 5 mm hex
    • 15 mm combination flex head wrench
    • 15 mm socket
    • Flex head ratchet/flex head torque wrench
  4. Remove the LH rear drop link from the vehicle.

Install

  1. Position the LH rear drop link to the vehicle.
  2. Install and tighten a new nut that attaches the LH stabilizer bar drop link to the LH rear suspension knuckle.
    55 Nm (40.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Counter-hold the ball joint with a 5 mm hex wrench.
    Informational PurposesAn informational icon, calling your attention
    Note
    Mark the nut with a paint pen after installation.
    Tip: Use of the following tool(s) is recommended:
    • 5 mm hex
    • 15 mm combination flex head wrench
    • 15 mm socket
    • Flex head ratchet/flex head torque wrench
  3. Install and tighten a new nut that attaches the LH rear drop link to the LH rear stabilizer bar.
    55 Nm (40.6 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 5 mm hex
    • 15 mm combination flex head wrench
    • 15 mm socket
    • Flex head ratchet/flex head torque wrench
  4. Install the rear aero shield panel. See Panel - Aero Shield - Rear (Remove and Replace).