15/04/2024 22:42:21

Wiper Blade - Driver Side (Remove and Replace)

Correction code 1750020052 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. On the touchscreen, touch Controls > Service > Wiper Service Mode to enable "Wiper Service Mode".
  2. Place a towel or shop rag underneath the wiper arm to prevent scratches on the windshield.
  3. Release the tab that attaches the LH wiper blade to the LH wiper arm, and then remove the LH wiper blade from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
    Figure 1. Releasing and Securing the Tab

Install

  1. Install the new LH wiper blade onto the LH wiper arm until the retaining tab is visible and an audible click is heard.
  2. Remove the towel or shop rag from the windshield.
  3. On the touchscreen, touch Controls > Service > Wiper Service Mode to disable "Wiper Service Mode".