06/02/2024 08:48:05

Mud Flaps (Retrofit)

Correction code 12207006 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-02-04: Updated the torque value and the recommended tools for the bolts that attach the mud flaps and the rocker covers to the body.
Table 1. Torque Specifications: Exterior Trim Fittings - Mud Flaps - Pair
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the LH mud flap and the rocker cover to the body
3 Nm (2.2 lbs-ft)
  • Cordless Ratchet/Impact Driver
  • 10 mm deep socket
  • Ratchet/torque wrench
 Reuse

Procedure

  1. Open the LH front door.
  2. Turn the steering wheel fully to the left to provide access to the working area.
  3. Remove the clips (x2) that attach the LH front wheel arch liner to the body.
  4. Use a small flat head screw driver to open the front LH lower rocker panel bolt access cover.
  5. Remove the bolt that attaches the rocker cover to the body.
    Tip: Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 10 mm deep socket
    • Ratchet/torque wrench
  6. Put on cut-resistant gloves, and then use a retractable blade knife to carefully cut off the open access cover from the rocker cover.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Ensure cut-resistant gloves are worn during this step to avoid personal injury.
  7. Position the LH mud flap onto the wheel liner and the rocker cover, then secure the clips (x2).
  8. Install the bolt to attach the LH mud flap and the rocker cover to the body.
    3 Nm (2.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 10 mm deep socket
    • Ratchet/torque wrench
  9. Repeat step 2 to 8 for the RH side.
  10. Center the steering wheel.
  11. Close the LH front door.