Clevis Pin - Brake Pedal (Remove and Replace)
Correction code 3325010212 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Remove
- Remove the driver footwell cover. See Cover - Footwell - Driver (Remove and Replace).
- Remove the LH footwell duct. See Duct - Footwell - LH (Remove and Replace).
-
Release the cotter clip that attaches the brake clevis clip pin to the
pedal assembly.
NoteRemove the cotter clip by hand.
-
Remove the brake clevis clip pin from the brake pedal assembly, and then
release the clevis clip from the pedal.
NoteWiggle the brake pedal to aid in pin removal.
Install
-
Align the brake pedal with the iBooster rod, and then install the brake
clevis clip pin that attaches the clevis clip to the brake pedal
assembly.
WarningThe video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
-
Install the cotter clip that attaches the brake clevis clip pin to the
pedal assembly.
NoteMove all parts to their original positions. Replace the cotter clip if damaged.
- Install the LH footwell duct. See Duct - Footwell - LH (Remove and Replace).
- Install the driver footwell cover. See Cover - Footwell - Driver (Remove and Replace).