License Plate Light (Remove and Replace)
Correction code
1740020052
FRT
0.12
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how
they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection
to make sure wearing proper PPE when performing the below procedure.
NOTE: See Ergonomic Precautions for safe and
healthy working practices.
- 2025-12-26: Added the trunk latch cover steps.
Remove
- Remove the trunk latch cover. See Cover - Latch - Trunk (Remove and Replace).
- Remove the trunk lid trim. See Trim - Lid - Trunk (Remove and Replace).
-
Disconnect the electrical connector from the license plate light.
-
Push the license plate light
towards the RH of the vehicle to compress the clip, and then compress the
clip on the other side of the light to remove the light.
Install
-
Install the license plate light to the vehicle.
-
Connect the electrical connector to
the license plate light.
- Install the trunk lid trim. See Trim - Lid - Trunk (Remove and Replace).
- Install the trunk latch cover. See Cover - Latch - Trunk (Remove and Replace).