Windshield Washer Bottle and Pump - Connection Hose Assembly (Remove and Replace)
Correction code
1750030102
FRT
0.18
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy
working practices.
Remove
- Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
-
Release the clip and then disconnect the main washer hose.
-
Release the clips (x4) that attach the washer hose to body and washer
bottle.
-
Place absorbent material below the washer pump hose connection point to
collect spilled washer fluid.
-
Release the clip and disconnect the washer hose from the washer pump, and
then remove the washer hose from the vehicle.
Install
-
Connect the washer hose to the washer pump.
- Remove the absorbent material from below the washer pump hose.
-
Install the clips (x4) that attach the washer hose to body and washer
bottle.
-
Connect the main washer hose.
- Install the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
- Fill the windshield washer reservoir with fluid.
- Close the washer reservoir cap.
- Verify operation of the windshield wipers and washer.