Flood Port (Remove and Replace)
Correction code 1601010072 FRT 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Only technicians who have been trained in High Voltage Awareness and have completed all required certification courses (if applicable) are permitted to perform this procedure. Proper personal protective equipment (PPE) and insulating HV gloves with a minimum rating of class 0 (1000V) must be worn at all times a high voltage cable, busbar, or fitting is handled. Refer to Tech Note TN-15-92-003, High Voltage Awareness Care Points
for additional safety information.
Remove
- Raise and support the vehicle. See GUID-0ECF2493-88F6-48E9-ADBB-9AE1D52E217C.html.
- Remove the rear aero shield panel. See Panel - Aero Shield - Rear (Remove and Replace).
- Remove the rear HV battery skid plate. See Skid Plate - HV Battery - Rear (Remove and Replace).
-
Remove the LH floor port from the LH underside of the HV battery
ancillary bay.
NoteTwist the flood port while pulling down.
- Repeat step 4 to remove the RH floor port from the RH underside of the HV battery ancillary bay.
Install
- Use an IPA wipe to clean the area around the openings where the flood ports were removed.
-
Install a flood port into the opening at the LH underside of the HV battery
ancillary bay.
NotePress up firmly to fully seat the flood port.
- Repeat step 2 to install a flood port into the RH underside of the HV battery ancillary bay.
- Install the rear HV battery skid plate. See Skid Plate - HV Battery - Rear (Remove and Replace).
- Install the rear aero shield panel. See Panel - Aero Shield - Rear (Remove and Replace).
- Remove the vehicle from the lift. See GUID-0ECF2493-88F6-48E9-ADBB-9AE1D52E217C.html.