2025-02-05

Puddle Lamp - Front Door (LH) (Remove and Replace)

Correction code 1513021712 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Use a small screwdriver or pry tool to release the clips that attach the front door puddle light to the bottom of the door trim panel, and then separate the light from the panel.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not pull the puddle light too far from the door panel, as the puddle light connector is still attached.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Be careful not to damage the door trim panel when using the small screwdriver or pry tool.
  3. Disconnect the electrical wiring harness from the front door puddle light connector, and then remove the light from the vehicle.

Install

  1. Connect the electrical wiring harness to the front door puddle light connector.
  2. Secure the clips that attach the front door puddle light to the bottom of the door trim panel.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the clips are fully engaged.
  3. Raise the LH front window and close the LH front door.