08/11/2023 22:54:03

Super Horn (Remove and Replace)

Correction code 2121010812 FRT 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Super Horn (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x3) that attach the pedestrian warning speaker to the valance
1.8 Nm (1.3 lbs-ft)
  • Cordless 1/4in Dr Ratchet
  • Torx T25 socket
  • Flex head ratchet/flex head torque wrench
 Replace

Remove

  1. Remove the RH front wheel. See Wheel Assembly (Remove and Install).
  2. Release the push clips (x9) that attach the RH front wheel arch liner to the vehicle, and then partially remove the RH front wheel arch liner.
  3. Release the clip that attaches the pedestrian warning harness to the speaker, and then disconnect the pedestrian warning connector.
  4. Remove the screws (x3) that attach the pedestrian warning speaker to the valance, and then remove the speaker from the valance.
    Tip: Use of the following tool(s) is recommended:
    • Cordless 1/4in Dr Ratchet
    • Torx T25 socket
    • Flex head ratchet/flex head torque wrench

Install

  1. Install the pedestrian warning speaker to the valance, and then install the screws (x3) that attach the pedestrian warning speaker to the valance.
    1.8 Nm (1.3 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Cordless 1/4in Dr Ratchet
    • Torx T25 socket
    • Flex head ratchet/flex head torque wrench
  2. Connect the pedestrian warning connector, and then install the clip that attaches the pedestrian warning harness to the speaker.
  3. Install the RH front wheel arch liner back to the vehicle, and then install the push clips (x9) that attach the RH front wheel arch liner to the vehicle.
  4. Install the RH front wheel. See Wheel Assembly (Remove and Install).