13/08/2024 22:36:51

Link - Stabilizer Bar - Front - LH (Remove and Replace)

Correction code 3101062022 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Link - Stabilizer Bar - Front - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Nuts that attach the front stabar link to the LH front stabar and the LH strut
98 Nm (72.3 lbs-ft)
  • Cordless Ratchet/Impact Driver
  • 18 mm socket
  • Ratchet/torque wrench
Replace 1111543-00-A

Remove

  1. Raise the vehicle fully. See GUID-0ECF2493-88F6-48E9-ADBB-9AE1D52E217C.xml.
  2. Remove and discard the nut that attaches the front stabar link to the LH front stabar.
    Tip: Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 18 mm socket
    • Ratchet/torque wrench
  3. Move LH front stabar link assembly aside.
    Informational PurposesAn informational icon, calling your attention
    Note
    Move the stabar up or down as needed to get the correct angle to remove the end link.
  4. Remove and discard the nut that attaches the front stabar link to the LH strut assembly, and then remove the LH front stabar link from the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 18 mm socket
    • Ratchet/torque wrench

Install

  1. Position the LH front stabar link assembly to the vehicle.
  2. Install a new nut (1111543-00-A) to attach the front stabar link to the LH strut assembly.
    98 Nm (72.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Mark after torque.
    Tip: Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 18 mm socket
    • Ratchet/torque wrench
  3. Position the LH front stabar link assembly to the front stabar.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull down the stabar as needed to allow the end link to engage.
  4. Install a new nut (1111543-00-A) to attach the front stabar link to the LH front stabar.
    98 Nm (72.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Mark after torque.
    Tip: Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 18 mm socket
    • Ratchet/torque wrench
  5. Lower the vehicle and remove the lift arms from below the vehicle.