26/12/2023 18:23:57

Shroud - Lower - Steering Column (Remove and Replace)

Correction code 1405010132 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2023-12-27: Added a step about installing the locator slot before installing the screws securing the lower shroud.

Remove

  1. Remove the upper shroud of steering column. See Shroud - Upper - Steering Column (Remove and Replace).
  2. Remove the lower screws (X2) that attaches the steering column lower shroud to the steering column, and then remove the lower shroud from the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • Cordless 1/4in Dr Ratchet
    • Torx T20 socket

Install

  1. Slide the lower shroud onto the steering column, make sure the locator slot is engaged.
  2. Install the lower screws (X2) that attaches the steering column lower shroud to the steering column, and then install the lower shroud from the vehicle.
    1.5 Nm (1.1 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Cordless 1/4in Dr Ratchet
    • Torx T20 socket
  3. Install the upper shroud of steering column. See Shroud - Upper - Steering Column (Remove and Replace).