16/02/2024 14:15:22

Wheel Assembly (Remove and Install)

Correction code 34015001 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Pull the inner side of the adjacent 2 claws of the wheel cap to remove the wheel cap from the wheel.
  2. Loosen the lug nuts.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Use only hand tools to break the lug nuts loose. Power tools should only be used to remove the lug nuts after they have been loosened.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Use a 6 point socket. Do not use a 12 point socket or a specialty socket.
  3. Raise and support the vehicle. See GUID-0ECF2493-88F6-48E9-ADBB-9AE1D52E217C.html.
  4. Remove the lug nuts from the wheel, and then remove the wheel from the vehicle.

Install

  1. Position the wheel to the vehicle, and then hand-tighten the lug nuts.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Wear appropriate personal protective equipment (PPE) when performing this procedure to prevent personal injury.
  2. Lower the vehicle. See GUID-0ECF2493-88F6-48E9-ADBB-9AE1D52E217C.html.
  3. Fully tighten the lug nuts in a criss-cross star pattern.
    175 Nm (129.1 lbs-ft)
  4. Position the wheel cap on the wheel and press the center of the cap firmly onto the wheel.