17/10/2023 18:50:20

Post Guide - Headrest - Front Seat (Remove and Replace)

Correction code 1307010142 FRT 0.78 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Seat base edges are sharp and can cause personal injury. Wear cut resistant gloves when removing the seat from the vehicle, and while performing procedures that involve work on or near the seat base.

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
  3. Remove the LH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  4. Remove the driver seat assembly. See Seat Assembly - 1st Row - LH (Remove and Replace).
  5. Remove the driver seat headrest trim. See Headrest - Front Seat (Remove and Replace).
  6. Remove the driver seatback assembly. See Trim - Seat Back - Front Seat - LH (Remove and Replace).
  7. Release the bayonets (x4) on the both sides of the two headrest post guides, and then pull the two headrest post guides upward to remove them from the seat back frame.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.

Install

  1. Install the bayonets (x4) that attach the headrest post guides to the seat back frame.
  2. Install the driver seatback assembly. See Trim - Seat Back - Front Seat - LH (Remove and Replace).
  3. Install the driver seat headrest trim. See Headrest - Front Seat (Remove and Replace).
  4. Install the driver seat assembly. See Seat Assembly - 1st Row - LH (Remove and Replace).
  5. Install the LH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  6. Install the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
  7. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).