2025-10-11
Blower - Backrest - Front Seat - LH (Remove and Replace)
Correction code
1301011012
FRT
0.18
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
NOTE: See Ergonomic Precautions for safe and healthy working practices.
Warning
Seat base edges are
sharp and can cause personal injury. Wear cut resistant gloves when removing the seat
from the vehicle, and while performing procedures that involve work on or near the seat
base.
Remove
- Remove the driver seat back shell. See Shell - Seat Back - Front Seat - LH (Remove and Replace).
-
Disconnect the electrical connector from the driver seat cushion
ventilation fan.
-
Rotate the fan to remove the
backrest ventilation fan.
Install
-
Rotate the fan counterclockwise to install the backrest ventilation
fan.
-
Connect the electrical connector to the driver seat cushion ventilation
fan.
- Install the driver seat back shell. See Shell - Seat Back - Front Seat - LH (Remove and Replace).