17/10/2023 18:49:31

Glass - Door Mirror - LH (Remove and Replace)

Correction code 1209010032 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
To avoid personal injury, eye protection must be worn when performing this operation.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
To avoid personal injury, wear cut-resistant gloves when performing this operation.
  1. Press the outside of the door mirror glass fully in so that it is angled away from the vehicle.
  2. Insert a plastic trim tool behind the glass in the bottom inboard corner, and then carefully release the tabs (x8) that attach the door mirror glass to the mirror assembly.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  3. Use a paint pen to mark the upper black harness connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    The paint marking is used to aid installation.
  4. Disconnect the electrical connectors (x3) from the door mirror glass.
  5. Remove the door mirror glass from the vehicle.

Install

  1. Connect the electrical connectors (x3) to the door mirror glass.
    Informational PurposesAn informational icon, calling your attention
    Note
    Refer to the paint marking made during removal to determine which electrical connector is the upper one.
  2. Align the center of the door mirror glass to the center of the door mirror assembly and then install the door mirror glass so that the tabs (x8) are fully engaged.
    Informational PurposesAn informational icon, calling your attention
    Note
    When aligned correctly, the metal tab on the door mirror glass goes the top right of the door mirror assembly.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage component(s).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  3. Adjust the door mirror glass back to its original location.
  4. Clean the door mirror glass to remove any smudges or fingerprints.