Rear Bumper Fascia - Fascia - Rear Lower Assembly (Remove and Replace)
Correction code
1001040032
FRT
0.60
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Torque Specifications
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| Bolts (x4) that attach the lower rear fascia to the upper rear fascia |
 3 Nm (2.2 lbs-ft) |
|
Reuse |
Remove
- Remove the rear fascia diffuser. See Rear Undertray and Diffuser - Diffuser Assembly, Rear Fascia (Remove and Replace).
-
Remove the bolts (x4) that attach the rear lower fascia to the rear upper
fascia.
Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- Cordless Ratchet/Impact Driver
- Remove the LH and RH rear fascia lamp assemblys. See Tail Lights - Lamp Assembly, Rear Fascia Lamp, LH (Remove and Replace).
-
Remove the tabs (x19) that attach the
lower fascia to the upper fascia.
Install
-
Install the tabs (x19) that attach the
lower fascia to the upper fascia from either side.
CAUTIONTake care not to damage painted fascia.
- Install the LH and RH rear fascia lamp assemblys. See Tail Lights - Lamp Assembly, Rear Fascia Lamp, LH (Remove and Replace).
-
Install the bolts (x4) that attach the
lower rear fascia to the upper rear fascia. 3 Nm (2.2 lbs-ft)Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- Cordless Ratchet/Impact Driver
- Install the rear fascia diffuser. See Rear Undertray and Diffuser - Diffuser Assembly, Rear Fascia (Remove and Replace).