08/12/2023 01:10:26

Camera Cover - Upper (Remove and Replace)

Correction code 1505010022 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Camera Cover - Upper (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x2) that attach the interior camera to the camera upper cover
1 Nm (.7 lbs-ft)
  • Ratchet/torque wrench
  • Torx T10 bit
  • 1/4 in to 1/4 in hex bit adapter
  • Wiha Torque Screwdriver 0.8-5 Nm (for installation only)
 Reuse

Remove

  1. Remove the lower camera cover. See Camera Cover - Lower (Remove and Replace).
  2. Remove the rear view mirror. See Mirror - Rear View (Remove and Replace).
  3. Release the clips (x4) that attach the upper camera cover, disconnect the interior camera connectors (x3), and then remove the upper camera cover and interior camera assembly from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not pull the upper camera cover with excessive force, as the electrical harness is still attached to the interior camera.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  4. Remove the screws (x2) that attach the interior camera to the upper camera cover, and then remove the interior camera from the upper camera cover.
    Tip: Use of the following tool(s) is recommended:
    • Ratchet/torque wrench
    • Torx T10 bit
    • 1/4 in to 1/4 in hex bit adapter
    • Wiha Torque Screwdriver 0.8-5 Nm (for installation only)

Install

  1. Position the interior camera onto the upper camera cover, and then install the screws (x2) that attach the interior camera onto the upper camera cover.
    1 Nm (.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Ratchet/torque wrench
    • Torx T10 bit
    • 1/4 in to 1/4 in hex bit adapter
    • Wiha Torque Screwdriver 0.8-5 Nm (for installation only)
  2. Connect the interior camera connectors (x3), and then install the clips (x4) that attach the upper camera cover to the vehicle.
  3. Install the rear view mirror. See Mirror - Rear View (Remove and Replace).
  4. Install the lower quad camera cover. See Camera Cover - Lower (Remove and Replace).