17/10/2023 18:53:33

Shield - Body Controller - Front (Remove and Replace)

Correction code 1715010022 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Shield - Body Controller - Front (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the front body controller shield to the front body controller
8.5 Nm (6.3 lbs-ft)
  • 10 mm socket
  • Cordless Ratchet/Impact Driver
  • Ratchet/torque wrench
 Reuse

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Disconnect the LV power. See LV Battery - Li-lon (Disconnect and Connect).
  3. Remove the LV power. See LV Battery (Remove and Replace).
  4. Use a pocket screwdriver to press the connector tab, then push it to the left to disconnect the thermal sub-harness electrical connector from the front body controller.
  5. Remove the bolts (x2) that attach the front body controller shield to the front body controller, then remove the front body controller shield.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
    • Cordless Ratchet/Impact Driver
    • Ratchet/torque wrench

Install

  1. Position the front body controller shield onto the front body controller, then install the bolts (x2) that attach the front body controller shield to the front body controller.
    8.5 Nm (6.3 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
    • Cordless Ratchet/Impact Driver
    • Ratchet/torque wrench
  2. Connect the thermal sub-harness electrical connector to the front body controller.
  3. Install the LV power. See LV Battery (Remove and Replace).
  4. Connect the LV power. See LV Battery - Li-lon (Disconnect and Connect).
  5. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).