17/10/2023 18:49:40
Cover - Shock Tower - LH (Remove and Install)
Correction code
1225010011
FRT
0.12
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Remove
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Remove the cabin intake duct. See Assembly - Fresh Air Gutter - HVAC (Remove and Replace).
- Remove the access panel. See Cover - Hood Latch (Remove and Replace).
- Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
-
Release the clips (x3) that
attach the LH shock tower cover to the vehicle, and then remove the cover
from the vehicle.
Install
-
Install the clips (x3) that attach the LH shock tower cover to the vehicle.
- Install the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
- Install the access panel. See Cover - Hood Latch (Remove and Replace).
- Install the cabin intake duct. See Assembly - Fresh Air Gutter - HVAC (Remove and Replace).
- Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).