2023-10-17

Brake Shield - Front (Base Brakes) - LH (Remove and Replace)

Correction code 3301010032 FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Brake Shield - Front (Base Brakes) - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x3) that attach the LH front brake dust shield to the knuckle
8 Nm (5.9 lbs-ft)
  • Torx T30 socket
  • Cordless Ratchet/Impact Driver
  • 2 in extension
 Reuse

Remove

  1. Remove the LH front hub (dual motor). See Hub Assembly - Front - LH (Dual Motor) (Remove and Replace).
  2. Remove the bolts (x3) that attach the LH front brake dust shield to the knuckle, and then remove the dust shield from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T30 socket
    • Cordless Ratchet/Impact Driver
    • 2 in extension

Install

  1. Position the LH front brake dust shield to the vehicle, and then install the bolts (x3) that attach the dust shield to the knuckle.
    8 Nm (5.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T30 socket
    • Cordless Ratchet/Impact Driver
    • 2 in extension
  2. Install the LH front hub (dual motor). See Hub Assembly - Front - LH (Dual Motor) (Remove and Replace).