17/10/2023 18:56:23

Bushing - Front Drive Unit - RH (3DU) (Remove and Replace)

Correction code 3901010092 FRT 2.82 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Place the vehicle on the 2-post lift.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure the vehicle is not charging.
  2. Remove the front subframe. See Subframe Assembly -Front (Remove and Replace).
  3. Install the bushing removal cups and stud onto the RH bushing, and use cups K, B and I to drive the bushing out of the front drive unit.
    Informational PurposesAn informational icon, calling your attention
    Note
    Always apply torque to the bearing side when removing or installing a bushing. Drive the bushing until the cup and bushing assembly is fully removed from the front drive unit.
    Tip: Use of the following tool(s) is recommended:
    • Combination Wrench 12pt 22mm
    • Ratcheting Combination wrench Fixed head 22mm
    • Drive Unit Bushing Kit
  4. Remove cups and the old bushing from the threaded stud.

Install

  1. Install the bushing press cups with a new bushing into position.
  2. Use cups L, J and C to press the bushing into the front drive unit.
    Informational PurposesAn informational icon, calling your attention
    Note
    When installing a new bushing, ensure the rubber tab is visible at the top of cup J. Always apply torque to the bearing side when removing or installing a bushing. Press the new bushing in until the flange on the bushing makes contact with the front drive unit case.
    Tip: Use of the following tool(s) is recommended:
    • Combination Wrench 12pt 22mm
    • Ratcheting Combination wrench Fixed head 22mm
    • Drive Unit Bushing Kit
  3. Remove cups from the front drive unit, and inspect the alignment of the RH bushing.
  4. Install the front subframe. See Subframe Assembly -Front (Remove and Replace).