2025-03-17

Foam - Cushion - Front Seat (Remove and Replace)

Correction code 1307010102 FRT 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2025-03-17: Added note regarding cushion foam heating wire replacement.
  • 2024-03-28: Added steps of installing new occupancy sensor and new seat cushion heating wire to the new seat cushion foam.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Seat base edges are sharp and can cause personal injury. Wear cut resistant gloves when removing the seat from the vehicle, and while performing procedures that involve work on or near the seat base.

Install

  1. Route the connector of the new occupancy sensor through the notch, and then stick the new sensor onto the new seat cushion foam.
  2. Install the seat cushion heating wire onto the cushion foam.
    Informational PurposesAn informational icon, calling your attention
    Note
    Install a new seat cushion heating wire.
  3. Install the driver seat cushion foam.
  4. Install the driver seat cushion cover. See Trim - Cushion - Front Seat - LH (Remove and Replace).