Foam - Cushion - Front Seat- LH (Sport Seat) (Remove and Replace)
Correction code
1307020102
FRT
0.78
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and FRT
listed above reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times
to learn more about FRTs and how they are created.
NOTE: See Personal Protection
to make sure you are wearing proper PPE when performing the procedure
below.
NOTE:
See Ergonomic Precautions for
safe and healthy working practices.
Remove
- Remove the driver seat cushion trim. See Cover- Front Seat Cushion- LH (Sport Seat) (Remove and Replace).
-
Remove the driver seat cushion foam.
Install
-
Route the connector of the new occupancy sensor through the notch, and then stick the
new sensor onto the new seat cushion foam.
-
Install the seat cushion heating wire onto the cushion foam.
- Install the driver seat cushion trim. See Cover- Front Seat Cushion- LH (Sport Seat) (Remove and Replace).