25/03/2024 17:29:07

Wing - Lower - Active Spoiler (Remove and Replace)

Correction Code 12222302

Removal

  1. Use the touchscreen to move the active spoiler to the extended position:
    1. Touch Controls.
    2. Touch Settings.
    3. Touch Service & Resets.
    4. Slide the "Spoiler" bar to Extend.
  2. Remove the middle liftgate trim. See Trim - Liftgate - Middle (Remove and Replace).
  3. Remove the LH and RH side liftgate trims. See Trim - Liftgate - Side - LH (Remove and Replace).
  4. Remove the spoiler applique and the high mounted brake light. See Lamp - Brake - High Mounted (Remove and Replace).
  5. Clean off any excess adhesive from the spoiler applique and the spoiler lower wing.
  6. Remove the bolts (x4) (torque 6 Nm) that attach the active spoiler lower wing to the spoiler stanchions, and then remove the active spoiler lower wing.

Installation

Installation procedure is the reverse of removal, except for the following:

  • After installation, calibrate the rear spoiler:
    1. Connect a laptop with Toolbox 3 to the vehicle.
    2. Unlock the vehicle gateway. See Gateway Unlock.
    3. In Toolbox 3, click the Actions tab, type "X_Spoiler" into the search field, click PROC_BCREAR_X_SPOILERSearch for routine in ToolboxRun BCREAR Spoiler Routine, click Run, and allow the routine to complete.
    4. Disconnect Toolbox and remove the laptop from the vehicle.
  • Use the touchscreen to cycle the active spoiler up and down. Make sure that it works properly.