03/03/2020 13:18:43

Panel - Door Trim - Front - LH (Remove and Install)

Correction Code 15130201

Removal

  1. Fully lower the window.
  2. Open the front door.
  3. Use a trim tool to remove the decorative trim from the door panel.
  4. Remove the rubber cover from the base of the pull cup.
  5. Release the fastener beneath the rubber cover (torque 6 Nm).
  6. Release the fasteners (x3) that secure the trim panel (torque 6 Nm).
  7. Release the clips that secure the trim panel; have an assistant support the trim panel, but do not remove it at this time.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use an inflatable air wedge to release the clips.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not damage the door module harness that is still connected to the trim panel.
  8. Disconnect the latch release cable.
  9. Raise the window.
  10. Disconnect the window switch harness.
  11. Remove the door panel and place it on a flat, soft surface.

Installation

Installation procedure is the reverse of removal, except for the following:

  • Replace plastic heart flex door trim clips after each use.
  • Reuse metal clips unless they are damaged.
  • When reinstalling the manual release cable, ensure that it is routed inboard of the window guide rail.