18/11/2021 09:24:10
Applique - Liftgate (Remove and Replace)
Correction Code 12207002
Special tool required for this procedure:
Supplier | Part Number | Description |
Tesla | 1049517-00-A | Ergonomic Silicone Seam Roller |
Removal
-
Apply protective tape around the perimeter of the applique.
CAUTIONProtective tape prevents the exterior paint surfaces from being damaged.
-
Using a trim stick or other suitable tool, carefully and evenly release the clips (x6) that attach the applique to the liftgate.
CAUTIONTake care not to damage component(s).
- Remove the liftgate applique from the vehicle.
- Remove the protective tape.
Installation
CAUTION
Do not use a rubber wheel, heat gun, or any other means of removing adhesive that generates heat. Using one of these methods to remove adhesive can result in cracking to the taillights.
-
If reinstalling the original applique:
- Remove the double-sided tape.
- Clean the inside of the applique with an alcohol wipe and allow it to dry completely.
- Apply new double-sided tape to the applique.
- Remove the backing from the double-sided tape.
-
Install the 2 center clips that attach the applique to the liftgate.
NoteComponents have been removed in this graphic to aid clarity.
- Working outwards from the center of the applique, install the remaining 4 clips that attach the applique to the liftgate.
- Working outwards from the center of the applique, press firmly on the applique using a silicone seam roller to completely seal the double-sided tape.
-
Temporarily apply tape to both ends of the applique to apply pressure.
-
Wait at least 5 minutes before removing the tape.
CAUTIONFailure to wait at least 5 minutes before removing the tape can result in improper adhesion of the double-sided tape.