19/08/2022 02:26:11

Light - Fog - Front - LH (Remove and Replace)

Correction Code 17404002

Removal

  1. Remove the LH front wheel, see Wheel Assembly (Remove and Install).
    Informational PurposesAn informational icon, calling your attention
    Note
    Use a 2-pole lift or a floor jack with jack stand.
  2. Remove the clips (x7) and nut (torque 6 Nm) that attach the front portion of the wheel arch liner to the wheel arch, and then move the front part of the wheel liner towards the rear of the vehicle for access.
  3. Disconnect the turn/fog light electrical connector.
  4. If equipped, remove the bolt (torque 6 Nm) that attaches the wheelhouse air duct to the LH front turn/fog light assembly.
  5. Release the clips (x2) that attach the front fascia harness to the LH wheelhouse air duct.
  6. Release the LH wheelhouse air duct from the LH front fender garnish, and then remove the LH wheelhouse air duct from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Take care not to damage the parking sensor harness,
  7. Release the clips (x2) that attach the front fascia harness to the front turn/fog light assembly.
  8. Remove the bolts (x2) that attach the top of the turn/fog light assembly to the front fascia (torque 2.5 Nm).
  9. Release the screws (x2) that attach the base of the turn/fog light assembly to the front fascia (torque 2 Nm).
  10. Remove the LH turn/fog light assembly from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:

  1. After installation, adjust the fog light(s). See Lights - Fog - Front (Adjust).