24/08/2020 16:07:44

Rear Door Hinge - Primary - Front - LH (Remove and Replace)

Correction Code 11338002

Removal

  1. Open the RH rear door to allow vehicle ingress during the remaining steps.
  2. Remove both LH rear door springs (refer to procedure).
  3. Close the rear LH door; make sure that it latches securely.
  4. Release the fir tree clip that secures the door harness to the upper door. Move the harness away from the primary hinge.
  5. Mark the location of the front primary hinge on the body and on the upper door.
    Informational PurposesAn informational icon, calling your attention
    Note
    This helps to install the new primary hinge into the same place.
  6. Remove the bolts (x2) that attach the hinge to the upper door (torque 24 Nm).
  7. Remove the bolts (x3) that attach the hinge to the body (torque 38 Nm).
  8. Remove the hinge from the body.
    Informational PurposesAn informational icon, calling your attention
    Note
    The door might move during removal.

Installation

Installation procedure is the reverse of removal, except for the following:

  • Use the marks made in the Removal section to align the new hinge in the same location as the old hinge.
  • Touch and hold the CALIBRATE button on the Model X touchscreen until the rear doors have been fully calibrated, close completely, and the message "CALIBRATION COMPLETE" is displayed.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the rear door requires adjustment, refer to TN-16-11-002, "Adjusting the Rear Doors (Falcon Wing Doors) on Model X" for instructions.