28/08/2020 14:09:58
Tuner - Radio (Remove and Replace)
Correction Code 21220102
Removal
- Disconnect the 12V battery. See Disconnect 12V Power.
- Remove the driver's side lower dash trim. See Trim - Dash - Driver's Side - Lower (Remove and Replace).
-
Open the latch and disconnect the
electrical connector from the amplifier.
CAUTIONTake care not to damage component(s).
- Remove the LH footwell cover. See Assembly - Cover - Footwell - Driver's (Remove and Replace).
-
Remove the screws that attach the
OBD connector to the amplifier/tuner bracket (torque 4 Nm).
- Release the OBD connector from the cross car beam and set aside.
-
Disconnect the electrical
connectors from the radio tuner.
-
Release the fir tree clips that
attch the electrical harnesses to the bracket.
- Remove the bolts that attach the amplifier/tuner and bracket assembly to the cross car beam (torque 6 Nm).
-
Remove the screws that attach the
radio tuner to the bracket (torque 4 Nm).
- Release the radio tuner from the bracket.
Installation
Installation procedure is the reverse of removal, except for the following:
- Reinstall the latest vehicle firmware, or update the firmware if not the latest. See Firmware Reinstall - Touchscreen or Firmware Update.