18/06/2021 06:24:22

Panel - Door Trim - Rear - Upper - LH (Remove and Replace)

Correction Code 15132302

Removal

  1. Remove the lower rear door garnish (refer to procedure).
  2. Carefully release the clips (x17) that secure the rear upper door trim panel, but do not fully remove the trim panel from the vehicle.
  3. If equipped, disconnect the upper door harness.
    Informational PurposesAn informational icon, calling your attention
    Note
    Only older versions of the rear upper door trim panel are equipped with the connector and related sensors.
  4. Remove the rear upper door trim panel from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:
Informational PurposesAn informational icon, calling your attention
Note
New rear upper door trim panels are no longer fitted with sensors and a harness connector. Configuration changes are not required since the original sensor functions are disabled by any firmware updates from 2016.32.6 onwards.
Informational PurposesAn informational icon, calling your attention
Note
Replace the plastic heart flex clips after each use.
Informational PurposesAn informational icon, calling your attention
Note
Reuse the metal clips unless they are damaged.
  1. Before installing the rear upper door trim panel, use a tie wrap to attach the redundant connector (vehicle side) to the harness to prevent any NVH issue to occur.