26/03/2020 16:14:16

Window Motor/Regulator Assembly - Rear - LH (Remove and Replace)

Correction Code 11502202

Removal

  1. Remove the rear window (refer to procedure).
  2. Disconnect the electrical connector from the window motor.
  3. Remove the upper nuts (x2) that secure the regulator to the door (torque 10 Nm).
  4. Remove the lower nuts (x2) that secure the regulator to the door (torque 10 Nm).
  5. Push the regulator outboard so that the studs no longer protrude through the door shell.
  6. Push the 2 beams of the regulator together and remove the window motor/regulator assembly from the door.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not allow the washers to fall off the studs on the regulator.

Installation

Installation procedure is the reverse of removal, except for the following:
Informational PurposesAn informational icon, calling your attention
Note
Close the door latch with a small screwdriver before testing the new window regulator. The door latch must be closed in order for the new window regulator to function.