03/03/2020 13:18:43

Cinching Actuator - Door - Rear - LH (Remove and Replace)

Correction Code 11353502

Removal

  1. Remove the closeout panel (refer to procedure).
  2. Remove the fasteners that attach the cinching actuator to the door.
    Informational PurposesAn informational icon, calling your attention
    Note
    If present, remove and discard any bolt shims.
  3. Pull up on the actuator to gain access to the latch cable. Disconnect the latch cable from the actuator.
  4. Remove the actuator from the vehicle.

Installation

Informational PurposesAn informational icon, calling your attention
Note
If the rear door requires adjustment, refer to TN-16-11-002, "Adjusting the Rear Doors (Falcon Wing Doors) on Model X" for instructions.
  1. If necessary, adjust the cinching actuator isolators (x3) so that they are oriented as pictured.
  2. Hand-tighten the cinching actuator mounting bolts to the actuator, as pictured.
  3. Connect the latch cable to the cinching actuator.
  4. Slide the cinching actuator shroud onto the actuator.
  5. Align the cinching actuator shroud with the actuator mounting holes, and then install the self tapping screws (x2) that attach the shroud to the actuator (torque 2 Nm).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not use power tools to install the screws.
  6. Position the cinching actuator on the rear door, and then install the nuts that attach the actuator to the door (torque 3 Nm).
  7. Install the closeout panel (refer to procedure).