2022-05-12

Harness - Door - Front - LH (Remove and Replace)

Correction code 17100102

Removal

  1. Remove the LH front door trim panel (refer to procedure).
  2. Remove the LH front door closeout panel (refer to procedure).
  3. Disconnect 12V power (refer to procedure).
  4. Remove the LH front door controller module (refer to procedure).
  5. Disconnect the LH window motor.
  6. Remove the LH front door speaker (refer to procedure).
  7. Disconnect the LH door mirror connectors.
  8. Disconnect the LH door pop actuator connector.
  9. Disconnect the door handle connector.
  10. Disconnect the latch connector.
  11. Disconnect the connector to the LH front door drive unit.
  12. Remove the bolt (torque 9 Nm) that attaches the LH front door harness ground wire to the door.
  13. Release the clips (x10) that attach the LH front door harness to the door.
  14. Release the clip that attaches the harness below the LH front door drive unit.
  15. Release the clip that attaches the harness to the base of the LH front door.
  16. Release the grommet from the LH front door.
  17. Remove the harness from the LH front door.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the grommets through the door, and then pull the harness out through the closeout panel access opening.
  18. Move the LH front A-pillar carpet aside.
  19. Disconnect the LH front door connectors (x4) from the main center body harness.
  20. Release the LH front A-pillar grommet.
  21. Remove the LH front door harness from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:
  • Install new double sided tape onto the Bluetooth sensor before installation.
  • Calibrate the falcon doors.