04/04/2022 14:07:22

Brake Hose - Flexible - Rear - LH (Remove and Replace)

Correction Code 33030502

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
If the vehicle has air suspension, activate "Jack" mode on the touchscreen before raising and supporting the vehicle.
Informational PurposesAn informational icon, calling your attention
Note
Replace the flexible brake hose whenever the caliper is replaced, or the banjo bolt is loosened.

Removal

  1. Remove the rear portion of the wheel arch liner and move it away from the working area (refer to procedure).
  2. Place a suitable container under the vehicle to collect brake fluid.
  3. Clean the areas that surround the connections at each end of the brake hose.
  4. Remove the bolt that attaches the brake hose to the caliper (torque 42 Nm).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Plug pipe connections to prevent ingress of moisture or dirt.
    Informational PurposesAn informational icon, calling your attention
    Note
    Place suitable absorbent material around the affected area to absorb any possible fluid spillage.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If brake fluid is spilled on a painted surface, wash off immediately with clean water.
  5. Loosen the nut that secures the brake pipe to to the brake hose, then disconnect the brake pipe from the hose (torque 14 Nm).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    To prevent damage always use a suitable wrench to hold the backing nut when loosening pipes and unions.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Plug pipe connections to prevent ingress of moisture or dirt.
    Informational PurposesAn informational icon, calling your attention
    Note
    Place suitable absorbent material around the affected area to absorb any possible fluid spillage.
  6. Note the orientation of the retaining clip that secures the brake hose to the fixed bracket. Remove the retaining clip and release the brake hose from the bracket.
  7. Note the orientation of the brake hose. Remove the brake hose from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Plug pipe connections to prevent ingress of moisture or dirt.

Installation

Installation procedure is the reverse of removal, except for the following:
Informational PurposesAn informational icon, calling your attention
Note
Clean the affected areas before installation.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Ensure that the brake hose is oriented correctly with no excessive twist or bends.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Ensure that the retaining clip that secures the brake hose to the fixed bracket is oriented correctly.
  1. Bleed the brake caliper (refer to procedure).