26/07/2023 17:02:40

Latch Actuator - 2nd Row Seat - LH (Remove and Replace)

Correction Code 13053002

Removal

  1. Remove the LH 2nd row seat back cover (refer to procedure).
  2. Remove the latch cable from the actuator, then remove the cable from the bracket.
    1 Actuator latch cable
    2 Cable bracket
  3. Disconnect the harness from the latch actuator.
  4. Gently lift the bottom corners of the 2nd row seat backrest cushion, then gently pull up on the bottom corners of the cushion to expose the seat internals.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not remove the cushion from the seat; the seat heater harness remains connected during this procedure.
  5. Working from the front of the seat, remove the fasteners that secure the latch actuator (torque 1 Nm).
  6. Working from behind the seat, remove the latch actuator.

Installation

  1. Install the new actuator and fasteners.
  2. Secure the latch cable to the actuator and the bracket.
  3. Connect the latch actuator harness.
  4. Pull the latching cable out of the seat back.
    Informational PurposesAn informational icon, calling your attention
    Note
    On some vehicles, the latching cable might be secured to the seat back with a cable tie. Cut the cable tie; ensure that a new cable is reinstalled during installation.
    Informational PurposesAn informational icon, calling your attention
    Note
    On some vehicles, the sides of the latching cable are secured together with a cable tie. Do not cut this cable tie.
  5. Connect a laptop with Toolbox 3 to the vehicle.
  6. Unlock the gateway. See Gateway Unlock.
  7. To disable seat install mode, in Toolbox 3, click the Actions tab, type "Seat-Install" into the search field, click PROC_BCREAR_X_SEAT-INSTALL-MODE-OFFvia Toolbox: (link), click Run, and allow the routine to complete.
  8. In Toolbox 3, click the Actions tab, type "PROC_BCS2L" in the search field, click PROC_BCS2L_R2-L_CALIBRATE-S2L-PITCHvia Toolbox: (link), click Run, and allow the routine to complete.
  9. In Toolbox 3, click the Actions tab, type "PROC_BCS2L" in the search field, click PROC_BCS2L_R2-L_CALIBRATE-S2L-TRACKvia Toolbox: (link), click Run, and allow the routine to complete.
  10. Disconnect Toolbox and remove the laptop from the vehicle.
  11. Secure the latching cable inside the seat back.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the cable was secured to the seat back with a cable tie, install a new one.
  12. Resecure the backrest cushion.
  13. Reinstall the seat back cover.