16/04/2020 10:17:59
Release Handle - Seat Track - 2nd Row - LH (Remove and Replace)
Correction code 13083102
Warning
This procedure is a DRAFT,
although it has been validated. Warnings and Cautions might be missing. Follow safety
requirements and use extreme caution when working on or near high voltage systems and
components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
- Open the LH front and LH rear doors
-
Move LH front seat forward
-
Remove 60 seat assembly release handle
NotePry at pivot point to release
-
Remove push clip securing LH outer front side shield on to seat
Note1x push clip
-
Move 60 seat fully forward using easy entry
-
Release J hooks that attach LH toe kick at back of seat
Note2x j hooks
-
Remove fastener securing LH outer rear side shield on to the seat
Note1x bolt, 10mm, 0.5 Nm
-
Remove second row LH outer side shield
Note4x clips, Release outer shield clips to help remove
-
Remove fasteners securing the track release handle
Note2x bolts, 10mm, 6 Nm
-
Remove release handle assembly from seat frame
NoteSlide release handle assembly towards front of the seat to remove from seat frame
-
Remove screws from release handle
Note3x screws, T20, 0.5 Nm, Pivot handle fully outward to gain access to the third fastener
-
Remove release handle pivot screw
Note1x bolt, T25, 4 Nm
-
Remove release handle from release handle assembly
Note1x cable, Pull release handle away from release handle assembly to remove while sliding cable out of handle
-
Install release handle to release handle assembly
Note1x cable, Slide cable into release handle before installing release handle to release handle assembly, Ensure the release cables are not crossed when installing
-
Install release handle pivot bolt
Note1x bolt, T25, 4 Nm
-
Install screws to release handle
Note3x screws, T20, 0.5 Nm, Pivot handle fully outward to gain access for the third fastener
-
Install handle assembly by sliding it into place
-
Install the fasteners securing the handle onto the seat
Note2x bolts, 10mm, 6 Nm
-
Install second row LH outer side shield
Note4x clips, Ensure rear cover is tucked behind seat retainer
-
Reinstall fastener securing LH outer rear side shield on to seat
Note1x bolt, 10 mm, 0.5 Nm
-
Reinstall J hooks that attach LH toe kick at back of seat
Note2x j hooks
-
Reinstall push clip securing LH outer front side shield on to seat
Note1x push clip
-
Install LH recline lever to splines
NoteInstall retainer clip to handle, Insert recline handle onto splines
-
Move 60 seat back and out of easy entry position
NoteMoving seat fully rearward will secure sliding plates to seat
-
Move LH front seat to original position
-
Close LH rear door
- Close LH front door