13/04/2023 13:48:17

Harness - Damper - Air Suspension - Front - LH (Remove and Replace)

Correction code 17101112 0.2 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
  1. Open LH front door
  2. Lower LH front window
  3. Place air suspension into "Jack Mode"
    Informational PurposesAn informational icon, calling your attention
    Note
    Using MCU touchscreen > Controls > Suspension > Jack Mode
  4. Remove LH front lug nut covers
    Informational PurposesAn informational icon, calling your attention
    Note
    5x lug nut covers
  5. Loosen LH front lug nuts
    Informational PurposesAn informational icon, calling your attention
    Note
    5x nuts, 21mm, 175 Nm
  6. Jack up LH front of vehicle
    Informational PurposesAn informational icon, calling your attention
    Note
    Position jack stand adapter onto jack and position on vehicle lift pad so that pin is located in center hole of vehicle lift pad, Jack up and position jack stand under vehicle, Lower jack so jack stand adapter is centered on jack stand
  7. Remove LH front wheel
    Informational PurposesAn informational icon, calling your attention
    Note
    5x nuts, 21mm, 175 Nm
  8. Remove clips securing LH front wheelhouse liner to body
    Informational PurposesAn informational icon, calling your attention
    Note
    14x clips
  9. Remove nuts securing LH front wheelhouse liner
    Informational PurposesAn informational icon, calling your attention
    Note
    2x nuts, 10mm, 6 Nm
  10. Remove LH front wheelhouse liner from vehicle
  11. Disconnect LH front adaptive air spring module harness connector
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector
  12. Disconnect LH front adaptive air spring module connectors
    Informational PurposesAn informational icon, calling your attention
    Note
    2x connectors
  13. Remove LH front adaptive air spring module harness from brackets
    Informational PurposesAn informational icon, calling your attention
    Note
    2x grommets
  14. Connect LH front adaptive air spring module connectors
    Informational PurposesAn informational icon, calling your attention
    Note
    2x connectors
  15. Connect LH front adaptive air spring module harness connector
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector
  16. Install LH front adaptive air spring module harness onto brackets
    Informational PurposesAn informational icon, calling your attention
    Note
    2x grommets
  17. Install LH front wheelhouse liner on vehicle
  18. Install nuts securing LH front wheelhouse liner
    Informational PurposesAn informational icon, calling your attention
    Note
    2x nuts, 10mm, 6 Nm
  19. Install clips securing LH front wheelhouse liner to body
    Informational PurposesAn informational icon, calling your attention
    Note
    14x clips
  20. Install LH front wheel
    Informational PurposesAn informational icon, calling your attention
    Note
    5x nuts, 21mm, 175 Nm, Start lug nuts by hand before using power tool
  21. Remove jack stands and lower vehicle
    Informational PurposesAn informational icon, calling your attention
    Note
    Raise jack stand pad up and remove jack stand then lower jack slowly and remove
  22. Torque LH front wheel
    Informational PurposesAn informational icon, calling your attention
    Note
    5x nuts, 21mm, 175 Nm
  23. Install LH front lug nut covers
    Informational PurposesAn informational icon, calling your attention
    Note
    5x covers
  24. Remove air suspension from "Jack Mode" and set to "Standard" if equipped
    Informational PurposesAn informational icon, calling your attention
    Note
    Using MCU touchscreen > Controls > Suspension > ''Standard''. Using MCU touchscreen > Controls > Service > ''JACK MODE''
  25. Raise LH front window
  26. Close LH front door