03/03/2020 13:18:43
Cage - Battery - Auxiliary - 12V (Remove and Replace)
Correction Code 17011402
Warning
If the 12V power
supply is disconnected, do not attempt to open any doors with door glass in
closed position. Failure to follow this instruction could result in door glass
shatter.
Note
Before
disconnecting the 12V power supply, ensure that the driver’s door window is
fully open. Failure to follow this instruction could result in vehicle
lockout.
Removal
- Disconnect 12V power (refer to procedure).
- Release the red plastic cover from the 12V positive terminal clamp.
- Disconnect the 12V battery positive terminal clamp (torque 5 Nm).
-
Release the edge clip and the barrel clip that secure the 12V harnesses from the
top of the battery cage.
-
Release the edge clip that secures the coolant hose to the bottom of the battery
cage.
-
Release the battery vent tube by gently pulling it way from the 12V
battery.
NoteThe following image shows the 12V battery ground connection still connected.
-
Remove the lower bolts (x2) that secure the battery cage to the plastic support
beam (torque 6 Nm).
NoteComponents have been removed in this graphic to aid clarity.
-
Remove the upper bolts (x2) that secure the battery cage to the crossmember
(torque 15 Nm).
NoteComponents have been removed in this graphic to aid clarity.
- Remove the battery and battery cage assembly from the vehicle and set it on a flat surface.
-
Remove the nut that secures the battery hold down bracket to the battery cage
(torque 4 Nm). Remove the battery hold down bracket.
- Lift the 12V battery straight up to remove it from the battery cage.
Installation
Installation procedure is the reverse of removal.