12/12/2022 06:53:44

Air Bag - Front Passenger's (Remove and Replace)

Correction Code 20010302

Informational PurposesAn informational icon, calling your attention
Note
In the event of an airbag or seat belt tensioner deployment, certain airbag and seat belt components must be replaced, and other components must be inspected for damage. Refer to SRS Inspection and Component Replacement for a specific list of items that must be inspected and replaced.

Remove

  1. Remove the top pad from the vehicle (refer to procedure).
  2. Use a large flat-blade screwdriver to release the front-facing airbag mounting tabs from the top pad.
    Informational PurposesAn informational icon, calling your attention
    Note
    The front-facing mounting tabs are on the side of the airbag that faces the windshield.
  3. Pull up on the front-facing side of the airbag to release the airbag from the top pad.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Store the air bag module with the deployment side facing up. This will prevent it from being propelled if accidentally deployed, which might cause injury.

Installation

Installation procedure is the reverse of removal, except for the following:
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Replace all patchbolt(s).
If the component was replaced due to an internal failure:
  1. Connect a laptop with Toolbox 3 to the vehicle.
  2. Unlock the vehicle gateway. See Gateway Unlock.
  3. In Toolbox 3, click Dashboards > Service Tools > DTCs, and then select SDM or RCM depending on the vehicle Restraint Control Type.
  4. Click Read DTCs to display the DTCs.
  5. Power cycle the vehicle.
  6. Click Clear DTCs to clear the DTCs.
  7. Disconnect Toolbox and remove the laptop from the vehicle.