20/01/2023 14:32:46
Wheels - Axle Set (Remove and Install)
Correction Code 34012401
Warning
"Jack mode" must be activated on vehicles with air suspension before lifting
the vehicle. Failure to do this might lead to suspension damage and could cause serious personal
injury.
Removal
- Position the vehicle on a lift but do not lift it at this time.
- If equipped, remove the lug nut covers.
-
On both sides of the vehicle,
initially loosen the lug nuts (x10) (torque 175 Nm).
CAUTIONDo not use an impact wrench to loosen tall lug nuts.
1 Short lug nut 2 Tall lug nut -
Raise and support the vehicle (refer to procedure).
WarningDo not work on an incorrectly supported vehicle.WarningTo avoid personal injury, use appropriate equipment when performing this operation.
- On both sides of the vehicle, remove the lug nuts (x5) and then remove the wheel.
Installation
Installation
Installation procedure is the reverse of removal, except for the following:
CAUTION
Tighten the lug nuts evenly using a diagonal sequence.
CAUTION
An impact wrench or electric wrench can be used only during the initial
threading of the lug nuts. Use a torque wrench to fully tighten the lug nuts.
CAUTION
Use a 6 point
socket to tighten tall lug nuts. Do not use a 12 point socket or a specialty
socket on tall lug nuts.
- If the TPMS sensors are not reinstalled in the same locations (for example, when rotating the tires), perform the TPMS sensor ID learn procedure (refer to procedure).