03/03/2020 13:18:43

Closeout Panel - Door - Rear - LH (Remove and Install)

Correction Code 11701401

Removal

  1. Remove the rear door trim panel (refer to procedure).
    Informational PurposesAn informational icon, calling your attention
    Note
    Vehicles built before approximately June 2016 require the curtain airbag harness to be disconnected. Since approximately June 2016, vehicles are built with a harness that is long enough to allow the curtain airbag harness to remain connected while the closeout panel is removed.
  2. Vehicles built before June 2016: Disconnect 12V power (refer to procedure).
  3. Disconnect the electrical connectors that are secured to the rear of the closeout panel.
  4. Disconnect the electrical connector from the ultrasonic door sensor module.
  5. Disconnect the electrical connectors from the rear door controller module.
  6. Release the push clip that secures each of the connectors to the closeout panel.
  7. Vehicles built before June 2016: Disconnect the curtain air bag connector:
    1. Ensure that the first responder loop has been disconnected for at least 2 minutes.
    2. Disconnect the electrical connector from the front of the curtain air bag.
      Warning IconA warning icon, calling your attention to a possibly risky situation
      Warning
      To avoid personal injury, observe all relevant safety precautions before removing or testing any SRS components.
      Warning IconA warning icon, calling your attention to a possibly risky situation
      Warning
      To avoid personal injury, eye protection must be worn when performing this operation.
  8. Remove the screws (x10) that secure the closeout panel to the door (torque 1.8 Nm).
  9. Remove the screws (x3) that secure the closeout panel to the window motor (torque 1.8 Nm).
  10. Release the rear door manual release cable from the closeout panel.
  11. Move the closeout panel out of the working area.

Installation

Installation procedure is the reverse of removal, except for the following:

Ensure that the door manual release cable is between the regulator and the door skin.