2020-03-03

Panel - Door Trim - Rear - LH (Remove and Install)

Correction Code 15132001

Removal

  1. Remove the lower rear door garnish (refer to procedure).
  2. Set the rear door to a comfortable working height.
  3. Move the driver's seat fully forward.
  4. Use a trim tool to release the small clips that secure the decorative trim to the door panel.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage component(s).
  5. Use a trim tool to release the large metal clips that secure the decorative trim to the door panel.
  6. Remove the bolts that secure the door trim panel to the rear door (torque 6 Nm).
  7. Use a trim tool to remove the heart flex clips that secure the trim. Discard the clips.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage component(s).
  8. While supporting the door trim panel, disconnect the forward electrical connector from the rear door controller.
  9. Remove the door trim panel from the vehicle and place it on a flat, clean surface.

Installation

Installation procedure is the reverse of removal, except for the following:

  • Replace plastic heart flex clips after each use.
  • Reuse metal clips unless they are damaged.